Driving trolley line, trolley trolley line, trolley line maintenance

Traffic trolley line, crane trolley line, trolley line maintenance - Yangzhou City Angli Sliding Line Electric Co., Ltd. specializing in the production of trolley line, trolley line variety, quality assurance!

First, must be based on different use of the environment, the use of a reasonable selection of product specifications, according to the equipment, continuation rate, the ambient temperature, the length of the line, equipment specifications, pay attention to leave a surplus, outdoor choice generally have to reduce capacity 20% use.

Second, when installing the trolley wire collector, be sure to pay attention to the lead wires of the trolley wire collector. Do not short-circuit or misassemble the phases during installation or installation.

Third, the housing of the trolley wire is equipped with an insulated slot plate, which must not be subjected to heavy pressure, hammering or violent impact. In order to avoid damage to the insulation effect of the trolley wire, causing unnecessary accidents and damage.

Fourth, in the use of the trolley line as far as possible to do a comprehensive inspection and maintenance every year, in the annual equipment maintenance, the HXTS, HXTL series multi-pole tube type trolley line device to carry out the following maintenance work:

1. Take the slide current collector from the end of the catheter and check whether the wear of the insert brush exceeds the effective length scale and replace it in time to check the wear condition of the neck.

2. Inspect the catheter. If there is any looseness or corrosion of the rails, replace the technology. Check if the clips and clips are loose.

3. Check whether the catheter has been deformed or bent significantly. Use the method of adjusting the position of the hanging bolt to straighten it. If there is bending or deformation, try to straighten it. If it cannot be straightened, it should be replaced immediately and it is forbidden to use it.

4. After one year of use of the trolley wire, there will be a lot of dust in the duct. You can blow it with compressed air or wipe it with a clean wire.

5. Check the collector brush spring pressure should be normal, generally 1.8-2.3N/Cm2.

6. Check the wheel wear condition. The roller can ensure the position of the brush in the up and down and left and right sides of the pipe. The excessive wear of the roller will cause the brush to be scratched or generate a power failure. The brush is a consumable item and needs frequent inspection and timely replacement.