It is best to perform the smart camera installation test before installing the smart camera. The smart camera installation test can omit some unnecessary troubles encountered by the smart camera during the installation process. Do you know how to do smart camera installation test? Do you know how to do the installation test? Let's take a look at the small series.
Smart camera installation test process:
1. Use the SYV75-3 video cable to make a test line with a BNC head on both ends of about 3 meters.
2, prepare a monitor or hard disk recorder, the hard disk recorder can be embedded or PC-style, software configuration is complete.
3. Before powering on, figure out the power supply voltage of the smart camera, and test the power supply voltage with a multimeter. The voltage deviation of the test is ±10% of the standard voltage. The power supply beyond this standard is forbidden.
4. Attach the lens to the fixed camera, pay attention to the interface between the lens and the camera, whether it is a C-type interface or a CS-type interface (this should be remembered, otherwise it is very likely to damage the camera when the C-type lens is directly screwed into the CS interface camera. CCD chip), if it is an integrated fixed camera, you can save this step.
5. Test AGCON/OFF (automatic gain control), ATWON/OFF (automatic white balance), ALC/ELC (automatic brightness control/electronic brightness control), BLCON/OFF (backlight compensation switch), LL/INT (synchronous selection) Switch), VIDEO/DC (lens control signal selection switch), SOFT/SHARP (detail level selection switch), FLICKERLE (no flash mode) and other functions, and test records, whether to meet the actual needs of the site.
6. According to the manual, the address, baud rate and protocol code of the decoder board are marked with label paper. The address code is sequentially coded according to the number of the camera. If there is no special requirement, the protocol is generally PELCO, and the baud rate is 2400KPS. Make the appropriate settings on the hard disk recorder or matrix.
The above is about the smart camera installation process. Does your home smart camera have been installed and tested before installation?
Waterproof Tile Stickers,Tile Decals,Kitchen Wall Tile Stickers,3D Tile Stickers
Fancy Tiles Co,. Ltd. , https://www.tilefancy.com